This video reviews a spool of filament I purchased in hopes it would be like PLA+ taken up a notch. What I ended up with was a regretful purchase.
I have been using this filament more since recording this and while I have had a little better luck with bed adhesion I do still have layer bonding issue.
Unfortunately if you crank the temp to the max recommended you get plenty of strings, zits & blobs. This forces you to use more fan which then causes more warping.
After running off a print at the max heat I noticed the finish is as shiny and maybe a little deeper black than the PETG I have which makes me question what this stuff really is.
It certainly does not have the ease of PLA when printing, it does warp about the same as PETG with anything higher than the slowest I can run my part cooling fan.
Please share you experience with this filament in the comments below.